Autopage MA-200 Installationshandbuch PDF herunterladen (Seite 3)

INTRODUCTION

This Remote Starter with Alarm and Keyless Entry System has been designed to be installed on fuel-injected vehicles with an

automatic transmission ONLY.

n Never install this remote starter on a manual transmission vehicle.

n This system must be installed and wired through a safety switch so it will not start in any forward or reverse gear.

n Some automatic transmission vehicles mainly older GM vehicles with a purple starter wire have a mechanical-type park

safety switch instead of electrical safety switch. The mechanical type does not interrupt the starter circuit when the

transmission is in any gear and does not offer the 100% level of safety required for remote starting purposes. Therefore, our

system should never be installed on any vehicle that uses a mechanical type park safety switch.

n Once you install this system, you must verify that the vehicle will not start in any forward or reverse gear, regardless of the

type of vehicle.

n Read the operation manual for operating.

n Do not install any component near the brake, gas pedal or steering linkage.

n Some vehicles have a factory installed transponder immobilizer system that can severely complicate the installation. There

is a possibility that this system cannot be installed on some immobilizer-equipped vehicles.

n Most vehicles have an SRS air bag system. Use extreme care and do not probe any wires of the SRS system.

n Disconnect the car battery before beginning work on the vehicle.

n Check behind panels before drilling any holes. Ensure that no wiring harness or other components are located behind the

panels that would otherwise be damaged.

n Do not use conventional crimp lock, bullet on any wiring. Poor wiring, i.e. taped joints will possibly introduce unreliability

into the alarm system and may result in false alarms or incorrect operation. We suggest soldering all connection points.

n Install the wiring neatly under carpets or behind trim to prevent possible damage to wires.

1 2 3 4 5 6 7 8 ... 28 29

Keine Kommentare

Autopage MA-200 Installationshandbuch Seite 3