1. Measure the resistance of the resistor pellet on the ignition key then select a resistor within 5% of the key’s value.
2. Locate the pair of VATS wires in the vehicle, usually a pair of thin gauge wires running from the ignition switch to the VATS
control module.
3. Connect the YELLOW wire from Remote Start Unit to TERMINAL #85 of an external relay. Connect terminal #86 of the relay
to a fused +12 volt.
4. Cut (#1) wire (as shown), and connect the ignition switch side of the cut wire to terminal #87a of the relay. Connect the
other side of the (#1) wire to terminal #30.
5. Connect the previously seleted resistor from terminal #87 to the second(#2) wire (as shown).
Ignition
Switch
YELLOW wire
Matching Resistor
VATS control Module
VAT wire (#1)
VAT wire
H6/14 GREEN WIRE – Negative Door Switch Sensing Input (Zone 3) –
This wire is the ground trigger input wire for negative door pin switch. This wire is connection for "grounding" type factory door
pins locate the "common wire" that connects the door pin switches. Make the connection of the GREEN Wire here.
H6/15 GRAY WIRE – (-) 200mA Channel 3 Output –
This will become a 1 second pulse ground by activate (button 3) on transmitter for two seconds, the current capacity of
this wire is 200 mA. This feature allows you to remote control trunk release or other electric device. (Realay may be required).
H6/16 BLUE WIRE – Ground Instant Trigger Input (Zone 2) –
This wire is the ground trigger input wire for hood and or trunk pin switches
H6/17 WHITE/VIOLET WIRE – Positive Safety Shut Down Input –
H6/18 VIOLET WIRE – Positive Door Switch Sensing Input (Zone 3)–
This wire is the positive trigger input wire for positive door pin switch. This wire is connection for "positive" type factory door
pins(typical FORD MOTOR). Locate the "common wire" for all door pins and make the connection of the VIOLET Wire here.
H6/19 WHITE/BLACK WIRE – Negative Safety Shut Down Input – Hood trigger Input
The WHITE/BLACK wire provides an
instant shutdown for the remote start,
whenever it is grounded. Connect the
wire to the hood pin switch previously
installed. This wire must be routed
though a grommet in the firewall and
connected to the hood pin switch.
This will also act as a hood trigger for
the alarm system
Negative safety & Hood
Trigger
Hood Pin
Important! This connection is a safety wire and m ust be connected as shown and tested as specifiled. Failure to do so may
result in personal injury or property damage. See detail of wiring in the following diagram. This wire may also be used if the
This wire provides an instant shutdown for the remote start,
whenever it gets +12volts. If the brake lights switch in the
vehicle switches +12 volts to the brake light circuit, connect
this wire to the output side of the brake switch. This will allow
the remote start to shut down if an attempt is made to operate
the vehicle without the key while running under the control of
the remote start. In most vehicles, in order to shift gear, the
brake pedal must be depressed. The brake input will in turn
cause the remote start unit to shut off. See diagram.
+12 volts from fuse box
wire
Brake light bulbs
When brake is
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern